Bonded vs No-Separation Contact in ANSYS Mechanical Static Structural
Choose between bonded and no-separation contact for clamped interfaces, then verify with Contact Pressure and Contact Status.
Loading…
ReadMeFeed / Community knowledge
#ansys-mechanical
Real questions. Useful conversations. Find the people who know your stack.
Choosing Contact Types in Ansys Mechanical for Bracket Assemblies
Match bonded, no-separation, or frictional contact to each bracket joint, then verify with contact status and pressure plots.
Choosing Pure Penalty or Augmented Lagrange Contact in Ansys Mechanical
Decide when to use Pure Penalty versus Augmented Lagrange contact in Ansys Mechanical for sliding assemblies, with configuration steps and convergence trade-offs.
ansysStabilizing Bolt Preload Convergence in Ansys Mechanical with Augmented Lagrange Contact
Use Augmented Lagrange contact with stabilization to converge bolt preload in Ansys Mechanical, then verify with mesh refinement and hand calculation.
Selecting Contact Formulations in Ansys Mechanical for Structural Assemblies
A technical guide to selecting contact formulations in Ansys Mechanical. Compare Bonded, Frictional, and Rough contacts to balance convergence speed with physical accuracy.
Diagnosing Newton-Raphson Non-Convergence in Ansys Mechanical
A diagnostic guide for resolving Newton-Raphson non-convergence in Ansys Mechanical, covering load stepping, contact instability, and material nonlinearity.
Solving Local Stress Peaks with Ansys Mechanical Submodeling
Learn how to use Ansys Mechanical submodeling to resolve local stress concentrations without the computational cost of a globally refined mesh.
When and How to Enable Large Deflection (NLGEOM) in Ansys Mechanical
Turn on Large Deflection when rotations exceed roughly 5–10 degrees or displacements are large enough that the undeformed geometry no longer represents the structure accurately.
Automatic Contact and Elastic-Plastic Nonlinear Static in Ansys Mechanical for Fast Design Checks
Nonlinear static with automatic contact in Ansys Mechanical speeds validation of latches and clips, but results depend on mesh density in contact zones and calibrated elastic-plastic curves.